Section 75 00-02-0878
2013-03-07 - 49 -
Parameter Access
To gain access to adjust the parameters, the password level must be entered:
If the password level is not entered, it is not possible to enter the parameters.
NOTE: The customer password can be changed in parameter
9111. The service password can be changed in parameter 9112.
The master password can be changed in parameter 9113.
NOTE: The factory passwords must be changed if the operator of
the genset is not allowed to change the parameters.
NOTE: It is not possible to change the password at a higher level
than the password entered.
Engine Communication
EMS-GC10 Unit and Engine Controller
The EMS-GC10 unit is able to communicate with an engine controller through the CAN
bus (CAN A).
NOTE: Information about engine communication can be found in
this manual Appendix I.
To Next Page
Loading...
