Murphy EMS-GC10 - Engine Types

Section 75 00-02-0878
2013-03-07 - 110 -
Functional Description
Electronic Control Module (ECM)
ECM
This communication extracts information from the Electronic Control Module (ECM) of an
engine equipped with an ECM module with CANbus interface. The values can be used as
display values, alarms/shutdown alarms and values to be transmitted through Modbus.
Engine Types
Data can be transmitted between the EMS-GC10 units and the following engine
controllers/types:
Engine
Manufacturer
Engine Controller/Type Comment
Caterpillar ADEM III and A4/C4.4, C6.6, C9, C15, C18, C32 Read/Write
Cummins
CM570 and CM850/QSL, QSB5 and 7, QSM11,
QSK19, 50 and 60
Read/Write
Detroit Diesel DDEC III and IV/Series 50, 60 and 2000 Read/Write
Deutz EMR3, EMR 2 (EMR)/912, 913, 914 and L2011 Read/Write
- Generic J1939 Read/Write
Iveco
EDC7 (Bosch MS6.2) / Series NEF, CURSOR and
VECTOR 8
Read/Write
John Deere JDEC/PowerTech M, E and Plus Read/Write
MTU
MDEC, module M.302 or M.303/lSeries 2000 and
4000
Read Only
MTU
MDEC, module M.201 or M.304/Series 2000 and
4000
Read Only
Select M.303
MTU ADEC/Series 2000 and 4000 (ECU7) Read/Write
MTU J1939 Smart Connect/Series 1600 (ECU8) Read/Write
Perkins Series 1100, 1300, 2300, 2500 and 2800 Read/Write
Scania EMS Read Only
Volvo Penta EDC4
Read Only
Select EMR 2
Volvo Penta EMS Read Only
Volvo Penta
EMS 2 and EDCIII/D6 D7, D9, D12 and D16 (GE
and AUX variants only)
Read/Write
NOTE: Read/Write: Please go to the section “Specific Engine Type
Descriptions” for details of data read and write.
NOTE: The engine type is selected in parameter 7561.
NOTE: For support of controller/engine types not listed, please contact
FW Murphy