Murphy EMS-GC10 - Volvo Penta EMS 2 (J1939)

Section 75 00-02-0878
2013-03-07 - 139 -
Volvo Penta EMS 2 (J1939)
EMS 2 and EDCIII/D6, D7, D9, D12 and D16 (GE and AUX variants only).
Warnings and Shutdowns
Warning/shutdown list
J1939
codes
SPN FMI warning FMI shutdown
Low oil pressure
100
5
-
Intake manifold #1 P
102
-
-
Coolant temperature
110
5
-
High inlet air temp.
172
5
-
Fuel temperature
174
-
-
Fuel pressure
94
5
-
Oil level
98
5
-
Overspeed
190
-
0
Coolant level low
111
-
1
EIC yellow lamp
-
X
-
EIC red lamp
-
-
X
EIC malfunction
-
X
-
EIC protection
-
X
-
NOTE: FMI indication “-“ means that the alarm in question is not supported.
Write Commands to Engine Controller
• Engine Controls
All the write commands to the engine controller (ex: speed, start/stop, etc.) are
enabled in parameter 7563 (EIC Controls)
• Engine Speed
CANbus ID for speed control: 0x0cff4611 – Volvo Penta proprietary telegram
M-Logic commands are available to enable/disable start/stop and speed controls:
• EIC start/stop enable
• EIC speed control inhibit
• Preheat
• Start/Stop
Readable States - Preheat and Running
NOTE: The speed regulation is enabled in parameter 2781 (Reg. output) and
7563 (EIC Controls).
NOTE: Selection of primary or secondary speed is selected in parameter
2774.