Section 75 00-02-0878
2013-03-07 - 164 -
The M-Logic configuration can also be saved/opened to/from a file using the default
save/open buttons.
Save: Activating this button makes it possible to save the M-Logic
configuration to file (part of the general EMS-GC10 configuration file
“.USW”).
Open: Activating this button makes it possible to open a previously
saved logics file.
Basic
Functions
The M-Logic consists of a number of “lines”, Logic 1, Logic 2 and so on. Each of these
lines have three event settings, two operator settings, one enable tick box and one
output setting.
The Logic line can be collapsed or expanded using this button. The free text will still be
shown.
NOTE: The free text is stored in the .usw file, but not in the product
itself.
The available functions are Events A, B, and C. These are used to trigger the logic.
To Next Page
Loading...
