Murphy EMS-GC10 - Scania EMS (J1939)

Section 75 00-02-0878
2013-03-07 - 135 -
Write Commands to Engine Controller
None.
Scania EMS (J1939)
Warning/Shutdown
None.
Write Commands to Engine Controller
None.
Scania EMS 2 S6 (J1939)
Scania EMS 2 S6 (J1939)
NOTE: Scania EMS 2 S6 does not use the J1939 SPN/FMI (Suspect
parameter Number/Failure Mode Indicator) system for alarm handling.
Instead the DNL2 system is used. For this reason, the alarm handling is
also different.
Warnings and Shutdowns (DNL2 Alarms)
Below is a list of warnings and shutdowns that can be shown on the display. They will be
shown as an alarm in the alarm window. The alarms can be acknowledged from the display,
but they will be visible until the alarm disappears in the ECM module.
Warning/shutdown list DNL2 warning DNL2 shutdown
EMS warning
X
-
Low oil pressure
X
-
High coolant temp
X
-
Stop limit exceeded
-
X
Charge 61
X
-
EIC yellow lamp
X
-
EIC red lamp
-
X
EIC malfunction
X
-
EIC protection
X
-
NOTE: DNL2 indication “-“ means that the alarm in question is not
supported.
NOTE: Handling of alarms is only active when the engine is running.