Murphy EMS-GC10 - Log List

Section 75 00-02-0878
2013-03-07 - 13 -
If there are no alarms, the Alarm List (Log) will be empty.
The display example below indicates an unacknowledged alarm. This means: Bus
Bar U > Settings Group 1
Log List
The log is divided into three different lists:
• Event Log – closing of breaker and starting of engine
• Alarm Log – overcurrent or high cooling water temperature
• Battery Test Log – test OK or test failed
The event log contains up to 50 events, the alarm log contains up to 30 historical
alarms and the battery test log contains up to 52 historical battery tests.
Parameters—Only Available With USW
Parameters need to be configured through the Utility Software (USW) and not locally
available to be configured from EMS-GC10 unit.
Parameter
Description
1340
Busbar voltage trip.
2774
EIC speed ramp.
4220
RMI fuel level multi input 6.
4230
RMI fuel level multi input 6.
4250
4-20ma. multi input 7.
4260
4-20ma. Multi input 7.
4350
RMI fuel level multi input 7.
4360
RMI fuel level multi input 7.
4380
4-20ma. multi input 8.
4390
4-20ma. multi input 8.
4440
RMI oil psi multi input 8.
4450
RMI oil psi multi input 8.
4460
RMI water temp. Multi input 8.
4470
RMI water temp. multi input 8.
4550
Magnetic pickup wire break.
4601
Delta analog 1, 2, 3.
5000
Relay 03.