Section 75 00-02-0878
2013-03-07 - 5 -
Push-Buttons
Normal display: Scrolls the display down once. Programming: Decreases
setpoint value.
Normal display: Scrolls the display up once. Programming: Increases setpoint
value.
Resets horn relay. Extra function: Press and hold button 2 seconds to see
.
Enter menus/enter value/acknowledges alarm.
Jumps from parameter settings to display. Removes pop-up messages.
Initiates the test sequence.
Lamp test. One push will illuminate all LEDs for 3 seconds.
Manual/Block running mode selector. Press MAN twice to activate Block mode.
AUTO running mode selector.
Open breaker
.
Closed breaker
.
Stop engine (Manual, not auto) running mode.
Start engine (Manual, not auto) running mode.
To Next Page
Loading...
