Section 75 00-02-0878
2013-03-07 - 1 -
About This Document
General Purpose
This document is the Operator’s Manual for Murphy’s Automatic Genset Controller, the
EMS-GC10.
The general purpose of the Installation Manual is to provide the information needed to
operate the unit.
WARNING: Please make sure to read this document before working
with the EMS-GC10 controller and the Genset to be controlled.
Failure to do this could result in human injury or damage to the
equipment.
You may visit the Murphy website at http://www.fwmurphy.com/emsgc10 to download the
latest version of the configuration tool software and the EMS-GC10 Operator’s Manual part
number 00-02-0878.
You will need to purchase the TTL to USB cable (75000277) in order to use the Utility Software
(USW).
Intended Users
The document is intended for the person responsible for setup and operating the EMS-GC10
unit.
Address, Menu, Setting, Parameter
To promote consistently with the PC Configuration Tool called Utility Software (USW), this
document uses the word Parameter, where in some instances, may also be thought of as an
address, menu, or setting.
To Next Page
Loading...
