Section 75 00-02-0878
2013-03-07 - 63 -
Command Timers
The purpose of the command timers is to be able to (for example) start and stop the
genset automatically at specific times each weekday or certain weekdays. If auto mode
is activated, this function is available in Island Operation and Load Takeover operation.
Up to four command timers can be used (for example) for start and stop. The command
timers are available in M-Logic and can be used for other purposes than starting and
stopping the genset automatically. The settings are set up through the PC utility
software (USW)or the display. Each command timer can be set for the following time
periods:
• Individual days (MO, TU, WE, TH, FR, SA, SU)
• Or the following group of days
• MO, TU, WE, TH
• MO, TU, WE, TH, FR
• MO, TU, WE, TH, FR, SA, SU
• SA, SU
NOTE: To start in AUTO mode, the "Auto start/stop" command can
be programmed in M-Logic or in the input settings.
NOTE: The time-dependent commands are flags that are raised
when the command timer is in the active period.
To Next Page
Loading...
