Murphy EMS-GC10 - Page 138

Section 75 00-02-0878
2013-03-07 - 132 -
Warning
Below is a list of warnings that can be shown on the display. The warnings will be shown as an
alarm in the alarm window. The alarms can be acknowledged from the display, but they will be
visible until the alarm disappears in the ECM module.
Warning
list
Warning
list
Coolant temp. high
ECU power supply high
Charge air temp. high
ECU power supply low
Intercooler coolant temp. high
Generator temp. high
Lube oil temp. high
Holding tank high level
ECU temp. high
Holding tank low level
Engine speed too low
Generator winding 1 high temp.
Prelube fail.
Generator winding 2 high temp.
Start speed not reached
Generator winding 3 high temp.
Common alarm (yellow)
Ambient temp. high
Lube oil pressure low
Water in fuel 1
Coolant level low
Water in fuel 2
Intercooler coolant level low
Fuel temp. high
ECU defect
Exhaust bank A high temp.
Speed demand failure
Exhaust bank B high temp.
Power supply low voltage
Fuel high pressure 1
Power supply high voltage
Fuel high pressure 2
Overspeed
Day tank high level
Lube oil press. low
Day tank low level
Coolant temp. high
Run-up speed not reached
Lube oil temp. high
Idle speed not reached
Charge air temp. high