VJ-1324 OPERATION MANUAL Troubleshooting
7.1 Malfunctions and failures 251
(2) The printing position is incorrect (some parts of the media cannot be printed
on)
(3) Printing is blurred
(4) White or black lines appear on printed media
3 Does the media bend? Use the recommended media.
When using media other than the dedicated
one, set the Vacuum Fan menu.
4.2.1 Media
type
5.1.1.1.8
Vacuum Fan menu
No. Possible cause Remedy Reference
1 Is the loading position of the media correct? Set the media correctly.
3.4 Loading
media
2 Did you set up the origin and print position? Cancel or reset the settings of the origin and
print position.
5 Panel setup
menu
No. Possible cause Remedy Reference
1 Are you using the recommended media? Use the recommended media.
4.2.1 Media
type
2 Are you using the thick or thin media? Use the recommended media.
4.2.1 Media
type
3 Is the media printed on the printing surface? Confirm the printing surface of the media and
set it correctly.
3.4 Loading
media
4 Did you perform Alignment? Perform Alignment.
3.6 Adjust
Print
5 Did you perform Media feed compensation? Perform Media feed compensation.
4.2.6 Media
feed
compensation
6 Is the temperature setting of each heater
appropriate?
Set the temperature appropriately.
5.1.1.1.5 Pre-
heater menu to
5.1.1.1.7 Dryer
menu
7 Is the head height set to High? Return the head height to "Low".
4.2.5 Head
height adjustment
No. Possible cause Remedy Reference
1 Are you using the recommended media? Use the recommended media.
4.2.1 Media
type
2 Is the scroller set correctly? Set the scroller correctly.
3.4.1 Loading
roll media
3 Is the nozzle in good condition? Perform Head cleaning.
6.2.3 Head
cleaning
No. Possible cause Remedy Reference
To Next Page
Loading...
Need help?
General