MUTOH XPJ-461UF - Page 29

If not using the printer for a long time 29
[6]
Tap [Enter].
[7]
Tap [Enter].
The table moves to the front side of the printer.
[8]
Remove the media and the jig on the table, and then tap [Enter].
• The table, carriage and cleaning wiper move to gain access to daily
maintenance.
[9]
The message on the left will appear.
• You can start daily maintenance.
"Performing Daily Maintenance" P. 117
After the daily maintenance is complete, tap [Enter].
The message on the left will appear.
The printer automatically performs the Short cleaning.
[10]
• The sleep mode will start.
• To exit the sleep mode, tap [Enter].
Note
• While in sleep mode, the small LED light above the power button flashes every 5 seconds.
•
To set the timer for automatic head cleaning during sleep mode, see "Sleep Mode2: Cleaning Timer" P. 97.
• Depending on the elapsed time from the previous automatic maintenance, the printer may automatically execute head cleaning and/or
ink charging, etc., when it exits the sleep mode. Such operation does not depend on the sleep mode settings. It is an automatic
maintenance function of the printer.
SleepMode
Start   ー＞ Enter
DailyMaintenance
Start   ー＞ Enter
PleaseWait
UnloadMedia
thenTapEnter
PleaseWait
DailyMaintenance
End  ー＞ Enter
PleaseWait
Cleaning  **%
SleepMode
End   ー＞ Enter