MUTOH XPJ-461UF - Maintenance2: Reset Waste Ink; Maintenance3: CR Maintenance; Maintenance4: UV Scan

Maintenance2: Reset Waste Ink 91
Maintenance2: Reset Waste Ink
This resets the waste ink counter to zero.
"Resetting waste ink counter" P. 113
Maintenance3: CR Maintenance
Use this for replacing absorption material for the flushing box and the cleaning
wiper.
"Replacing absorption material for the flushing box" P. 128
"Replacing the cleaning wiper" P. 131
"Replacing the Emitting Window Glass on the UV-LED Lamp" P. 134
"Replacing UV-LED Lamp Filter" P. 137
Submenus
Tap [Enter] to replace the absorption
material for the flushing box.
• The carriage moves to the center of the
printer.
• The cleaning wiper moves upward.
After the replacement is complete, tap
[Enter].
• The printer moves the carriage and the
cleaning wiper back to each original
position.
Maintenance4: UV Scan
Performs further UV curing.
Use this when you want to promote ink curing by applying additional UV light.
Submenus
UV Scan1: Start
UV Scan2: Number of Scan
UV Scan3: Post Cure
Note
The range over which the UV scanning is executed will depend on the current settings for “Size” and “Origin” in the “MediaSetting” User
Type.
Maintenance2
ResetWasteInk
Maintenance3
CRMaintenance
CRMaintenance
Start  ー＞ Enter
CRMaintenance
End  ー＞ Enter
Maintenance4
UVScan
UVScan1
Start
UVScan2
NumberofUVScan
UVScan3
PostCure