MUTOH XPJ-461UF - Maintenance5: Ink Discharge

92 Maintenance5: Ink Discharge
UV Scan1: Start
Performs further UV curing when needed.
When the media is not loaded, “No Media” is displayed, and the screen returns to
the previous screen.
• Application is canceled when the [Cancel] key is pressed for 2 seconds and
more while applying UV light.
Setting
Tap [Enter] to start.
UV Scan2: Number of Scan
Sets the number of times to apply UV light on the area.
• The settings here are reflected on “UV Scan1: Start” and “UV Scan3: Post Cure”
only.
Setting
2 / <4> / 8 / 16
< > indicates the default setting.
UV Scan3: Post Cure
When it is set to “On”, the printer automatically performs post curing to apply
additional UV light after printing.
Setting
<Off> / On
< > indicates the default setting.
Maintenance5: Ink Discharge
Discharges the ink in the printer. This operation is performed before moving the
printer.
• Before transporting the printer?
"Transporting" P. 139
• When turning off the power for up to one month? "If not using the printer
for a long time" P. 25
UVScan1
Start
UVScan1
Start  −＞Enter
UVScan2
NumberofUVScan
NumberofUVScan
（2ー16）4
UVScan3
PostCure
PostCure：
Off
Maintenance5
InkDischarge