GT10 Configuration SettingsGT10/GT30
79
5.1 GT10 Configuration Settings
5.1 GT10 Configuration Settings
Before using the GT10 for the first time, it must be set up by entering the GT10
configuration settings indicated below. Always check and enter the settings under “Basic
communication area to PLC”. For instructions on setting up the GT10, see page 34.
5.1.1 Two Types of GT10 Configuration Settings
1. Entering configuration settings from GTWIN screen creation tool page 80..
Withthismethod,GT10configurationsettings are enteredfromGTWIN screen creation
tool, and the GT10 configuration file is sent to the GT10. Most items can be set using
this method.
GTWIN
GT10
GT10
configuration
file sent
2. Entering configuration settings from the GT10 main unit page 96..........
Some of the settings, such as the communication parameters, the internal clock, and
adjustments of the liquid crystal display contrast, can be set using the system menu of
the GT10. Settings are entered using the touch switches on the front of the panel.
GT10
Explanation of this function
Items in the GT10 Configuration Settings
Items that can be set from GTWIN
Items that can be set
either way
Items that can be set from the
GT10 system menu
Title setting Communication parameters
Clock division setting for the internal
clock
Type of PLC connected LCD contrast setting
Basic communication area to PLC Communication parameters
Communication parameters Memory initialization
Auto-paging screen settings Self-diagnosis
Startup screen (default screen) settings
Reference destination setting for clock
Backlight control
Touch sounds
Hold PLC device
GT internal device hold
To Next Page
Loading...