GT10/GT30
GT10 Configuration Settings
90
5.2 Entering Configuration Settings from GTWIN Screen Creation Tool
5.2.6 GT Configuration Settings: “Setup”
Clicking on the “Setup” tab in the “GT Configuration” dialog box displays the screen
shown below. Here, clock functions, backlight control, and other parameters can be
specified.
“Setup” screen
Clock
Clock
This is used to specify the reference destination for the clock displayed with the GT10.
Select one of the radio buttons.
GT Clock - - - When the time is displayed, the internal clock in the GT10 is used as a
reference for the value.
PLC Clock - - - When the time is displayed, the internal clock in the PLC is used as a
reference for the value.
If the “PLC Clock” is referenced for the clock setting, clicking on the
button displays
a screen where the type of device and the address can be specified.
Device Setting dialog box
The button functions as a backspace
key when entering addresses.
The button acts as a Clear key.
Click on the button to display the pull-down
menu, and select the device from that menu.
Enter the address using the ten-keys.
To Next Page
Loading...