NAiS GT10 - Chapter 4 Connecting and Communicating with the Plc

Chapter 4
Connecting and Communicating with the
PLC
This chapter explains how to connect the GT series to the FP series PLC, and how to
set up communications between the units.
4.1 Connecting the FPΣ 47...............................
4.1.1 Connecting to the COM. Port 47...............
4.1.2 Connecting to the TOOL Port 49...............
4.2 Connecting the FP0 50...............................
4.2.1 Connecting to the COM. Port 50...............
4.2.2 Connecting to the TOOL Port 52...............
4.3 Connecting the FP1 53...............................
4.3.1 Connecting to the COM. Port 53...............
4.4 Connecting the FP2/FP2SH 54........................
4.4.1 Connecting to the COM. Port 54...............
4.4.2 Connecting to the TOOL Port 55...............
4.5 Connecting the FP2/FP2SH Computer
Communication Unit 56...............................
4.6 Connecting the FP10SH 57...........................
4.6.1 Connecting to the COM. Port 57...............
4.6.2 Connecting to the TOOL Port 59...............
4.7 Connecting the FP10SH/FP3 Computer
Communication Unit 60...............................
next page