NAiS GT10 - Internal Wiring Connections for Ports; COM. Port; TOOL Port

SpecificationsGT10/GT30
11
1.4 Internal Wiring Connections for Ports
1.4 Internal Wiring Connections for Ports
1.4.1 COM. Port
When connecting the unit to the FP series, there is
no need to wire both the RS and CS.
Wiring and cables should be laid out in such a way
that cables are not affected by external noise. Also,
shielded wiring should be used for cables.
1.4.2 TOOL Port
Pin No. Contents
1 SG
2 SD
3 RD
4 N.C.
5 (+5 V)
The +5 V of Pin 5 is reserved for the FP
Programmer II. It should not be used for
any other application.
1
2
4
5
3