GT10 Configuration Settings
GT10/GT30
81
5.2 Entering Configuration Settings from GTWIN Screen Creation Tool
5.2.2 GT Configuration Settings: “Basic Setup”
Selecting [Configuration] on the [File] menu of GTWIN and then the sub-menu [GT
Configuration] displays the “Basic Setup” screen shown below.
This is used to specify the basic communication area used for communication between
the GT10 and PLC, and the environment required for GT10 operation.
“Basic Setup” screen
Title - - - The title of the configuration settings file is entered here. Titlesare convenient
if each GT10 has its own configuration settings.
PLC Model - - - The model of PLC specified when GTWIN is booted is displayed here.
GT Model - - - The model of GT specified when GTWIN is booted is displayed here.
Basic communication area to PLC
Thisisusedtospecifythemodeinwhichcommunicationtakes placebetweentheGT10
and PLC, and the internal PLC device used for basic communication.
Modes
Turn on the radio button for either “GT10 Mode” or “IOP01 Mode”.
- GT10 Mode - - - Select this if you are using the GT10 for the first time.
- IOP01 Mode - - - This mode is for users who are using a conventional model (I.O.P.
B01C / M01L / D01TL). If this mode is selected, the basic communication area for
communication between the GT10 and PLC is compatible with conventional models for
the most part, except for a few items.
REFERENCE
For information on the IOP01 mode, please see page 37, “IOP01 Mode”.
To Next Page
Loading...