NAiS GT10 - GT Configuration Settings: Hold PLC Device

GT10/GT30
GT30 Configuration Settings
122
6.2 Entering Configuration Settings from GTWIN Screen Creation Tool
6.2.7 GT Configuration Settings: “Hold PLC Device”
Clicking on the “Hold PLC Device” tab in the “GT Configuration” dialog box displays the
screen shown below. “Hold PLC Device” is a function that enables internal PLC device
values to be held on the GT30 side.
“Hold PLC Device” screen
Hold PLC Device
The Hold PLC Device function reads the values for the specified internal PLC device
to the SRAM in the GT30, and backs up the values.
Off - - - PLC devices are not held.
On - - - PLC devices are held (up to 24 words)
If “On” is selected for the above Hold PLC Device setting, “Device” and “Number of
Word” parameters are displayed. Clicking on the
button displays a dialog box like
thatshownbelow,wherethetypeofinitialdevice,theaddress,andthe number ofwords
can be specified.
Device Setting dialog box
Click on the button todisplay thepull-down
menu, and select the device from that menu.
Enter the address using the ten-keys.
The button functions as a backspace
key when entering addresses.
The button acts as a Clear key.