NAiS GT10 - Setting Mode: Memory Initialization; Memory)

GT10/GT30
GT30 Configuration Settings
130
6.3 Entering Configuration Settings from the GT30 Main Unit
6.3.6 Setting Mode: “Memory Initialization” (Clear Memory)
Touching [Setting] on the initial screen of the system menu and then the [Memory] key
of the setting mode menu displays the memory initialization screen. The internal user
memory of the GT30 is initialized here.
Memory initialization screen
Procedure for bringing up the screen
[Initial screen]
↓
[Memory]
Touching the [SRAM] key deletes clock data and Hold PLC Device data held in the
SRAM.
Touching the [FROM] key deletes screen data and main unit configuration settings
saved to the main unit user memory (F-ROM).
When either of the above keys is touched, a confirmation message reading
is displayed. To clear the data, touch the key. When
is displayed, the memory has been completely cleared.
Learning the shortcut keys saves time!
[RETURN]To complete the settings and return to the previous screen,
touch the [ESC] key.
CAUTION
•
[SRAM] initialization deletes the clock data and Hold PLC Device
data backed up in the SRAM. Please be sure that you want
to do this before initializing the SRAM.
•
[FROM] initialization deletes the base screen data and the main unit
configuration setting data (the main unit configuration
setting data returns to the default values) in the user
memory (F-ROM) of the main unit. Before initializing the
F-ROM, always save screen data to a floppy disk or
another medium with GTWIN.