NAiS GT10 - GT10 Installation Method

Installation and Wiring
GT10/GT30
21
2.1 Installation
2.1.2 GT10 Installation Method
Secure the GT10 to the installation panel using the four fittings and four screws
provided with the unit.
(1) Place the GT10 main unit in the installation panel.
(2) Insert the fittings into the grooves provided in the GT10 main unit, and tighten
the screws to secure the GT10 main unit to the installation panel.
Enlarged view
Four fittings and four screws provided
with the unit
CAUTION
•
Screw tightening torque
The screw tightening torque should be 0.1 N m to 0.25 N m.
•
Applicable panel thickness
A panel with a thickness of 1.0 mm to 6.0 mm should be used.
•
Installation angle
If the installation angle is between 60 degrees and 0 degrees
(horizontal), the operating voltage should be set to 25V DC or lower.
Installationangle
next page