NAiS GT10 - GT30 Installation Method

GT10/GT30
Installation and Wiring
22
2.1 Installation
•
Clearance when the GT10 is installed
When installing the GT10, if other parts are being installed to the
panel or cables are being wired to it, we recommend providing a
clearance of 30 mm to 50 mm/1.18 inch to 1.97 inch around the GT10.
This prevents cables from being damaged, and facilitates the
installation work. Also, make sure that the slits in the main unit are
never obstructed.
2.1.3 GT30 Installation Method
SecuretheGT30totheinstallationpanelusingthe twofittings andfour screwsprovided
with the unit.
(1) Place the GT30 main unit in the installation panel.
(2) Insert the fittings into the grooves provided in the GT30 main unit, and tighten
the screws to secure the GT30 main unit to the installation panel.
Installation panel
Attachment screws
Attachment fittings
Slits (located all the way around the periphery)