GT10/GT30
Connecting and Communicating with the PLC
66
4.10 Through Function
4.10 Through Function
With the GT series, communication can be set to take place automatically between the
COM. and TOOL ports in a “through function”. When the FP series tool software
installed in the computer connected to the GT series as shown below is booted, PLC
programs can be edited through the GT series.
Thethroughfunction does not require any specialsettings, andis always inthe standby
mode.
PLC
GT10/GT30
Connected by cable
to the COM. port or
TOOL port of the PLC
Screen
transfer
cable
AFC8503
Screen data
being sent
and received
Screen creation tool GTWIN
FP series programming tool FPWIN GR
Personal computer
The FPWIN GR and NPST-GR are
booted on the computer being used to
edit the GT series screens, and the PLC
programs can be edited and monitored
through the GT series.
PLC debugging
To Next Page
Loading...