SpecificationsGT10/GT30
7
1.2 GT10 Names and Functions of Parts
1.2.3 Names and Functions of Parts
(1) Liquid crystal display panel / touch panel
Various screens are displayed here. A touch panel is provided on the liquid crystal
display panel, and switches can be operated and data entered simply by touching the
panel.
(2) Front panel protective sheet
Thisprotectsthetouchpanelandkeepsitclean.Onesheetisattachedtothepanelwhen
the unit is shipped.
(3) Power supply terminal
The operation power supply is connected here.
(4) COM. port (PLC/external device connection port)
A device such as a PLC, a higher-order computer, or a microcomputer board can be
connected to this RS232C port. (One communication connector is provided as an
accessory when the unit is shipped.)
(5) TOOL port (GTWIN connection port)
This port is used to connect a personal computer in which the screen creation tool
GTWIN has been installed, using a dedicated cable (AFC8503).
(6) Operation mode setting switches
With the GT10, screen data and configuration settings data are stored in an internal
F-ROM,sonobatterybackupisneeded.However,datasuchasclockdataandtheHold
PLC Device Data is stored in the internal SRAM, and is backed up by the internal
secondary battery, which is charged when the power supply is turned on.
The operation mode setting switches control the ON/OFF settings for the secondary
battery backup function, the ability to shift to the system menu, and other functions.
Switch no. Function OFF ON
1
SRAM backup using
secondary battery
No Yes
2 Inhibits system menu shift Shift possible Shift inhibited
3 Usage inhibited Should always be in the OFF position
4
when unit is used
(7) Waterproof packing
This assures that the front panel is waterproof. One piece is provided as an accessory
when the unit is shipped.
ON
OFF
43
MODE
12
Operation mode setting
switches
(settings when shipped)
To Next Page
Loading...