NAiS GT10 - Wiring the COM. Port

GT10/GT30
Installation and Wiring
26
2.3 Wiring the COM. Port
2.3 Wiring the COM. Port
2.3.1 Wiring the COM. Port
Accessory communication connector/applicable wiring
The communication connector used for the COM. port (provided as an accessory with
the main unit) has a screw-tightening type of terminal base. The wiring shown below
should be used.
Accessory communication connector
The communication connector is made by Fenics Contact Co., Ltd.
No
of
pins
Fenics Model No.
N
o. o
f
p
i
ns
Model No. Product No.
5-pin
MC1, 5/5-ST-3,5 1840396
Applicable wiring (twisted wiring)
Size Conductor Cross-Section Surface Area
AGW#28 to 16
0.08 mm
2
to 1.25 mm
2
Applicable stick-type terminals with insulated sleeves
If stick-type terminals are used, the models listed below are marketed by Fenics
Contact Co., Ltd.
Maker Cross-Section Surface Size Fenics Co. Model
0.25 mm
2
AGW#24 AI 0,25 to 6 YE
Fenics Contact
0.50 mm
2
AGW#20 AI 0,50 to 6 WH
Fenics
Contact
Co., Ltd.
0.75 mm
2
AGW#18 AI 0,75 to 6 GY
1.00 mm
2
AGW#18 AI 1 to 6 RD
Crimp tools for stick-type terminals
Maker
Fenics Model No.
M
a
k
er
Model No. Product No.
Fenics Contact Co., Ltd.
CRIMPFOX UD6 1204436