Servicing and MaintenanceGT10/GT30
147
8.1 What the Internal Secondary Battery Does (GT10)
8.1 What the Internal Secondary Battery Does (GT10)
8.1.1 The Function of the Secondary Battery
Internal GT10 data is backed up in the following ways:
Screen data
GT10 configuration data
Stored in the F-ROM. (No battery backup required.)
Hold PLC Device data
Stored in the SRAM. (Backed up by the internal secondary
oc
a
a
GT internal device hold data
a
ery, w
c
sc
arge
w
en power
s supp
e
o
e
.
The No. 1 operation mode setting switch on the back of the GT10 is used to specify
whether or not the contents of the SRAM are backed up.
Switch no. Function OFF ON
1
SRAM backup using sec-
ondary battery
No Yes
2
Inhibits system menushift Shiftpossible Shiftinhibited
3
Usage inhibited Should always be in the OFF
4
position when unit is used
In order to prevent excessive discharging of the internal secondary battery when the unit is
shipped from the factory, the No. 1 operation mode setting switch is set to the “OFF” position.
Before turning on the power supply, always set the No. 1 operation mode setting
switch on the back of the GT10 to the “ON” position.
In order to back up the various types of data stored in the SRAM, as described above,
the No. 1 operation mode setting switch on the back of the GT10 should always be set
to the “ON” position before turning on the power supply.
GT10
Explanation of this function
* Secondary Battery Performance
Secondary battery performance, when operating at a normal temperature of 25°C, a
normal humidity of 65% RH, and a voltage of 24V DC, is as follows:
Item Details
Backup time
Min. 10 days when fully charged
Charge time
If the power has been off for 24 hours,it takes approx.15 min. to fully charge.
If the power has been off for 10 days, it takes approx. 2 hrs. to fully charge.
Service life
Approx. 7 years
ON
OFF
43
MODE
12
(status when shipped)
Operation mode setting switches
To Next Page
Loading...