i
How This Manual Is Configured
GT10/GT30 Main Unit
Before Using the GT series
This section describes items that should be confirmed and precautions that should
be observed before the GT series are used.
Chapter 1. Specifications
This chapter contains the names and specifications of the various parts of the GT
series, as well as a table of functions, wiring diagrams, and dimensions.
Chapter 2. Installation and Wiring
Thischapterexplains how the GT series should be installedand howwiring should be
connected.
Chapter 3. Setup
Thischapter describesthe setup procedures necessary when using the GT series for
the first time.
Chapter 4. Connecting and Communicating with the PLC
This chapter explains how to connect the GT series to the PLC and the FP series by
Matsushita, and how to set up communications between the units.
Chapter 5. GT10 Configuration Settings
This chapter describes the configuration settings for the GT10, and how they should
be entered.
Chapter 6. GT30 Configuration Settings
This chapter describes the configuration settings for the GT30, and how they should
be entered.
Chapter 7. Using the Various Functions
Functions such as switching GT series screens, backlighting, and buzzer control are
explained here.
Chapter 8. Servicing and Maintenance
This chapter describes servicing and maintenance procedures for the GT series, as
well as how optional items are handled.
Chapter 9. Troubleshooting
This explains what to do if there appears to be something wrong with the GT series,
or an error occurs.
Chapter 10. Documentation
ThissectionincludesBIN/HEX/BCD code correspondence tables, ASCIIcodetables,
cable specifications, and other information.
Screen Creation Tool Terminal GTWIN
Before Using Terminal GTWIN
ThissectioncontainsspecialprecautionsthatshouldbereadifyouareusingGTWIN.
Chapter 1. Preparation
This section explains how to install GTWIN in the personal computer, how to boot it,
and how to exit it.
To Next Page
Loading...
Need help?
General
