NAiS GT10 - Page 5

Table of Contents
GT10/GT30
iii
Chapter 2 Installation and Wiring
2.1 Installation 19.........................................................
2.1.1 Installation Environment 19......................................
2.1.2 GT10 Installation Method 21.....................................
2.1.3 GT30 Installation Method 22.....................................
2.2 Wiring the Power Supply 24.............................................
2.2.1 Wiring the Power Supply 24.....................................
2.3 Wiring the COM. Port 26................................................
2.3.1 Wiring the COM. Port 26........................................
2.3.2 Wiring Method 27..............................................
2.3.3 Precautions Concerning Wiring 27................................
Chapter 3 Setup
3.1 Setup Procedure for the GT10 31........................................
3.1.1 Setup Procedure 31............................................
3.2 Setting the Basic Communication Area Between the GT10 and PLC 34.......
3.2.1 What is the Basic Communication Area? 34.......................
3.2.2 GT10 Basic Communication Area Map 36.........................
3.3 Setup Procedure for the GT30 39........................................
3.3.1 Setup Procedure 39............................................
3.4 Setting the Basic Communication Area Between the GT30 and PLC 42.......
3.4.1 What is the Basic Communication Area? 42.......................
3.4.2 GT30 Basic Communication Area Map 44.........................
Chapter 4 Connecting and Communicating with the PLC
4.1 Connecting the FPΣ 47.................................................
4.1.1 Connecting to the COM. Port 47.................................
4.1.2 Connecting to the TOOL Port 49.................................
4.2 Connecting the FP0 50.................................................
4.2.1 Connecting to the COM. Port 50.................................
4.2.2 Connecting to the TOOL Port 52.................................
4.3 Connecting the FP1 53.................................................
4.3.1 Connecting to the COM. Port 53.................................
4.4 Connecting the FP2/FP2SH 54..........................................
4.4.1 Connecting to the COM. Port 54.................................
4.4.2 Connecting to the TOOL Port 55.................................