GT10/GT30
Connecting and Communicating with the PLC
48
4.1 Connecting the FP
Σ
CAUTION
Because loose wiring is used for connection to the FPΣ COM. port, no
dedicated cable is available. The cable should be provided by the
customer. When purchasing a cable, the following precautions should
be observed:
•
Shielded wire with a size of AGW#28 to 16 (conductor cross-section
surface area: 0.08 mm
2
to 1.25 mm
2
) should be used for connections.
•
For wiring procedures, please refer to “Wiring the COM. Port” on
page 26.
To Next Page
Loading...