7 Direction Finding Mode
146 IDA-3106 Narda
4. Press the Map softkey to switch to the Map menu.
The bearings are displayed.
Adding new bearings to a saved localization
You can also add new bearings to a saved localization.
1. Open the localization you want (see Loading a localization from the
memory on page 145).
2. Press the Add Bearings softkey to open the localization.
The Localization softkey is shown in red.
3. Take further bearings (see Localizing a signal source (Outdoor)
on page 139).
Adding saved bearings to an existing localization
Bearings that were taken and saved without reference to a localization can
also be added to a saved localization.
NOTE: This function is only available for outdoor localizations. The bearing to be
added must include GPS and compass data and use the same units as the
localization.
To add saved bearings to a localization:
1. Open the localization you want (see Loading a localization from the
memory on page 145).
2. Press the Add Bearings softkey to open the localization.
The Localization softkey is shown in red.
3. Open the saved bearing: Menu > Memory > Data Viewer > Select data
set > Recall Data Set.
4. Press the Add to Localization softkey.
The bearing is added to the opened localization.
5. If desired, add further bearings. Then press the Localization softkey to
close the localization and save it.
To Next Page
Loading...
