13 Measurement Data Memory
228 IDA-3106 Narda
To start storing values immediately:
3. Press the Start Now softkey.
Automatic storage is activated.
The screen displays the view of the operating mode previously
selected. The info line shows Time Controlled Storing and the
remaining recording time.
To start storing at the specified time:
4. Press the Prog Start softkey.
The screen displays the view of the operating mode previously
selected. The info line shows Time Controlled Storing and the
remaining time until the start of recording. Storing starts when the
countdown reaches 0.
To stop storing:
Storing stops automatically when the specified duration has elapsed. To
stop storing values before this, press the Stop softkey.
The operating mode is again displayed normally. You can view the
stored measurement values from the Memory menu (see Viewing
and recalling data sets on page 221).
To Next Page
Loading...
