16 Remote Control
242 IDA-3106 Narda
3. Start the application for controlling and managing the PC interface and
set the following interface parameters:
16.3 Connecting to the network
There is an Ethernet connector (100BaseT) located on the right hand side
panel of the device for connecting it to a network.
To make the connection to the network:
1. Connect the IDA to the network using a commercially available network
cable.
2. Adjust the network settings to match the network properties (see
Changing network settings on page 73).
The device can be remotely controlled via the network.
16.4 Activating / deactivating remote control
To activate remote control:
Transmit the command REMOTE ON;
The IDA-3106 switches to remote controlled operation.
The screen display switches off.
The keypad is disbled.
To deactivate remote control:
Transmit the command REMOTE OFF;
Remote control is deactivated.
The screen display switches on.
The keypad is enabled once more.
Parameter Setting
COM Port Optical or USB, as selected by connection made (item 1 above)
Baud rate 115200 Baud
Start bits 1
Data bits 8
Stop bits 1
Parity None
Handshake None (the IDA-3106 does not support any software handshake)
To Next Page
Loading...
