16.4 Activating / deactivating remote control
Narda IDA-3106 243
16.4.1 Solving problems
If the IDA-3106 does not switch to remote controlled operation, check the
following items:
• Is the IDA-3106 set to the correct interface: Optical, USB
(Main Menu • Settings: Remote Interface)?
• Have you used the correct remote control cable (see Connecting the
device to a PC on page 236) and is the cable OK?
• Do the interface parameters on the PC and the IDA-3106 match
(see Connecting to the PC on page 240)?
• Was the command REMOTE ON; transmitted correctly (Response = 0)?
To Next Page
Loading...
