The Control area indicating which parameters are displayed.
The large part of the Control area to the right is called the Parameter area. This gives you ac-
cess to the desired parameters:
The parameters for the Sound “Analovue.”
These parameters are organized into pages that you can select for displaying by clicking the
little labels at the top of the Control:
The pages allow you to display further parameters for your plug-in.
On each page, you can click and drag the knobs to adjust the corresponding parameters.
Example
As an example, adjust the amplification level of the second oscillator in your “Analovue” pre-
set. Do the following:
Adding a Bass Line
Accessing the Plug-in Parameters
MASCHINE - Getting Started - 103
To Next Page
Loading...
