⇨ A list of Groups appears on the right display:
4. Check that Button 4 above the displays is not fully lit and that the USER label under-
neath is not highlighted; if necessary, press Button 4 to disable it.
⇨ This will now allow you to select only Native Instruments factory content.
5. Move the 4-D encoder to the left or to the right in order to put the focus (indicated by the
brackets) on All Types.
6. Press and hold the 4-D encoder to view which Group types are available.
⇨ The right display shows the various types of Groups available (Kits, Loops, Multi FX) as
long as the 4-D encoder is pressed:
7. While holding the 4-D encoder, turn it to select Kits.
⇨ When you release the encoder, the right display shows the list of Groups again, but now
this list contains only drum kits. Note that you can also turn the 4-D encoder without
holding it to select the desired entry (the available types of Groups will not be displayed).
First Steps
Loading a Drum Kit from the Factory Library
MASCHINE - Getting Started - 37
To Next Page
Loading...
