⇨ By selecting this, a list of Projects will become visible on the right display.
3. Press Button 4 above the displays to enable it.
⇨ The USER label underneath gets highlighted:
This will select only User content.
4. If you have already created more than one Project, turn the 4-D encoder or Knob 8 until
My First Project is selected on the right display.
5. Press the 4-D encoder or Button 8 to load the Project.
6. Press BROWSER to leave the Browser.
The BROWSER button turns off.
→ You can continue to work on your tutorial Project.
You will note that every action you did on the controller is directly mirrored in the
Browser of the MASCHINE software. This is true in both directions.
Opening a Recent Project Using the Controller
Your MASCHINE controller also provides a handy way to open Projects on which you worked
recently:
1. Press FILE to open the File mode.
The right display shows a list of your recent Projects.
2. Turn the 4-D encoder or Knob 8 to select the desired Project from the list.
3. Press the 4-D encoder or Button 8 to load the selected Project.
Building Your Own Drum Kit
Opening Your Project
MASCHINE - Getting Started - 52
To Next Page
Loading...
