V10/V7.5/V5/V3.5 Installation and Operation Manual Jul.05.07
Contents Page
2.2.13.7 Power Level Adjust 2-11
2.2.13.8 System Reset 2-11
2.2.14 Serial Port 2-11
2.2.15 RF Performance Monitoring 2-11
2.2.15.1 RF Monitor Samples 2-12
2.2.15.2 Forward Power Level Sample 2-13
2.2.15.3 Reflected Power Level Sample 2-13
2.2.15.4 Power Amplifier Volts Sample 2-13
2.2.15.5 Exciter Forward Power Level Sample 2-13
2.2.15.6 Intake Air Temperature Sample 2-13
2.2.15.7 Exhaust Air Temperature Sample 2-13
2.2.15.8 Total PA Current Sample 2-13
2.2.16 Remote Alarm Indications 2-13
2.2.16.1 Summary Alarm 2-13
2.2.16.2 Battery/EEPROM Fail Alarm 2-13
2.2.16.3 High Reflected Power Alarm 2-14
2.2.16.4 Changeover Alarm 2-14
2.2.16.5 PA/Module Fail Alarm 2-14
2.2.16.6 Interlock Open Alarm 2-14
2.2.16.7 IPA/RF Fail Alarm 2-14
2.2.16.8 High Temperature Alarm 2-14
2.2.16.9 Low RF Alarm 2-14
2.2.17 Remote Status Indications 2-14
2.2.17.1 Remote Control Status 2-14
2.2.17.2 RF On Status 2-14
2.2.17.3 Active Exciter Status 2-14
2.2.17.4 Active IPA Status 2-15
2.2.17.5 Active IPA Power Supply Status 2-15
2.2.17.6 Active Fan Power Supply Status 2-15
2.2.17.7 Preset Status 2-15
2.2.17.8 Transmitter Ready Status 2-15
2.2.17.9 Valid Data Status 2-15
2.2.17.10 +15V Supply 2-15
2.2.18 Parts Supplied by Nautel 2-15
2.2.19 Parts Not Supplied by Nautel 2-15
2.2.20 Test Equipment and Special Tools 2-15
2.2.21 Available Options 2-16
2.2.21.1 Analog/Hybrid/All-Digital Option 2-16
2.2.21.2 Standby Exciter Option 2-16
2.2.21.3 Standby IPA Option 2-16
2.2.21.4 Standby LVPS and Fan Supply Option 2-16
2.2.21.5 Output Connector Option 2-16
2.2.21.6 Station Spares Kit Option 2-16
2.2.21.7 Site Spares Kit Option 2-16
2.2.21.8 Ac Power Surge Protector Panel Option 2-16
2.2.21.9 Closed Ventilation Option 2-16
2.2.21.10 NX-Link Ethernet Interface Option 2-16
To Next Page
Loading...
