Nautel V10 - 2.3 INSTALLATION; 2.3.6 Installing Ac Power Source Wiring; 2.4 COMMISSIONING PROCEDURES; 2.4.3 Initial Turn-On

V10/V7.5/V5/V3.5 Installation and Operation Manual Jul.05.07
Contents Page
2.3 INSTALLATION 2-17
2.3.1 Accepting the Shipment 2-17
2.3.2 Unpacking Instructions 2-17
2.3.3 Visual Inspection 2-17
2.3.4 Determining Control/Monitor Requirements 2-17
2.3.5 Installing External Control/Monitor Wiring 2-17
2.3.6 Installing Ac Power Wiring 2-19
2.3.7 Installing the Exciter and Connecting Inputs 2-20
2.3.7.1 M50 Exciter(s) 2-21
2.3.7.2 NE30 Exciter(s) 2-19
2.3.8 Installing RF Feed Coaxial Cable 2-22
2.3.9 Station Reference Ground 2-23
2.4 COMMISSIONING PROCEDURES 2-24
2.4.1 Precautions 2-24
2.4.2 Turn-On Prerequisites 2-24
2.4.3 Initial Turn-On 2-25
2.4.4 Placing Transmitter On-Air 2-26
3 OPERATING INSTRUCTIONS
3.1 INTRODUCTION 3-1
3.1.1 Precautions 3-1
3.2 EMERGENCY SHUTDOWN 3-1
3.2.1 Complete Shutdown 3-1
3.2.2 Turn Off RF Output 3-1
3.3 EXTERNAL SAFETY INTERLOCK 3-1
3.4 ELECTROSTATIC DISCHARGE PROTECTION 3-2
3.4.1 Discharging of Personnel 3-2
3.4.2 Handling/Storage 3-2
3.4.3 Tools/Test Equipment 3-2
3.4.4 Stress Current Protection 3-2
3.5 CONTROLS AND INDICATORS 3-2
3.5.1 Front Panel 3-3
3.5.2 Switching Power Supply Module 3-4
3.5.3 Control/Display PWB 3-4
3.5.4 Interconnect PWB 3-4
3.5.5 Remote Interface PWB 3-4
3.5.6 Power Module Interface PWB 3-4
3.5.7 Miscellaneous 3-4
3.6 DIAGNOSTIC DISPLAY 3-20
3.6.1 Pushbutton Switches 3-20
3.6.2 Main Screens 3-20
3.6.2.1 Transmitter Status Bar 3-20
3.6.3 View Faults 3-22
3.6.4 Change Power, Frequency or Mode 3-22
3.6.5 View RF Module Status and Fan Speed 3-23
3.6.6 View Events Log 3-24