6-136 Reflashing the Printer Firmware
/HID Only for K8 printers.
/NHPI Only for 7199 printers.
/PRTR Only for 7199 printers.
[parameter]––> Selections for interface parameter (Only for RS232 and
Ethernet interface):
For RS232 Only: Please key in the Baud Rate, Parity and Stop Bit
– Baud Rate Selection:
/[115200] | [57600] | [38400] | [19200] | [9600]
– Parity Selection:
/[none] | [even] | [odd]
– Stop Bit Selection:
/[1] | [2]
For WiFi / Ethernet Only: Please key in the IP Address
– IP Address Selection:
/[xxx.xxx.xxx.xxx] – xxx is a number from 0 to 255
For CPMI, IBMUSB and HID is ignore
[file] ––> Selections for the filename:
Any valid binary file with extension *.mfw | *.sfn |
*.dfn | *.ipl | *.lan | *.bin (Only for K8) | *.tbl (Only for SSCO6–
1ST/2ST and 7199) | *.cfg (Only for 7199)
[print(opt)] ––> Selections for the print (Optional Parameter):
/print (default) Print printer configuration form.
/noprint Bypass printing printer configuration form.
[status(opt)] ––> Optional for Return Status (Optional Parameter):
/noretstat (default) Utility will not return status code.
/retstat Utility will return status code.
[ErrorTimeOut(opt)] ––> Failsafe: Max Time Allowed for Called Exe
(Optional Parameter):
/ErrorTimeOut=xxx (minimum=420) xxx is number of Seconds – limit
3600.
Information : Please use RS232 Interface, when switching from ION <=>
NON ION
The following error message is displayed when correct parameters are not used:
Error: Too few / many command line parameters!
The following is an example of a command line:
TseFlash.com /7197–5X01/6X01 /m /COM1 /115200 /none /1 SP2M0609.MFW
/noskip /print /retstat
This command displays the GUI interface and a progress bar indicator shown in the
next section. The same GUI interface is displayed when the program is ran through the
GUI Windows GUI Printer Firmware Update Utility.
To Next Page
Loading...