INSTALLATION
2-30 DT700 User Manual
Figure 2.10 AC Adapter Connection
To connect a headset (Optional)
Note: There is no connector for a headset on the DT710 (ITL-2E) phone.
1 Connect the headset to the phone:
a. Insert the headset cord plug into the HEADSET connector on the back of the phone,
until you hear a click.
b. Thread the cord through the groove, as shown in the figure below.
Figure 2.11 Headset Connection
To connect a computer (Optional)
You can connect a computer to the network through the phone using a LAN cable if
there are a limited number of available ports on your local area network.
Note: If a device that is connected through the PC port on the back of the phone is
having connection issues, contact your system administrator to verify that the
PC port is enabled on the phone.
1 Insert the LAN cable into PC connector on the back of the phone, until you hear a click.
AC
Adapter
Plug
Phone
Groove
AC Adapter Cord
Connector for AC Adapter
To Next Page
Loading...
