. . . . .
BASIC PHONE OPERATION
DT700 Basic Call Operation
DT700 User Manual 4-59
Figure 4.17 Redial from Cursor Pad for DT710 (ITL-6DE) and DT730 (ITL-
12D, ITL-24D and ITL-32D) phones
HOLD/RESUME A CALL
To hold/resume a call
1 While on a call, press the Hold key to place the call on hold.
Figure 4.18 Hold Key
If the SIP server supports music-on-hold, the other party hears music-on-hold.
2 To resume the held call, press the Hold key, or press the Resume Soft Key.
Figure 4.19 Call on Hold and Resume Soft Key
• DT710 (ITL-6DE) Phones: Oh hold duration is displayed in MM:SS format for the
first hour, and then HH:MM for the remainder of the call. The maximum duration is
99:59:59.
• DT730 (ITL-12D, ITL-24D and ITL-32D) Phones: Oh hold duration is displayed in
HH:MM:SS format. The maximum duration is 99:59:59.
Note: During a held call, you can dial another party by pressing the
NewCall Soft Key, which provides dial tone.
If you have problems reconnecting to a call after it is put on hold, press the EndCall
Soft Key to terminate the call.
USING A HEADSET TO MAKE AND RECEIVE CALLS
If you have a headset attached to your phone and your phone has been configured
for the headset (see “To enable an external headset” on page 3-41), you can either
use the telephone handset or your headset when you make and receive calls.
To Next Page
Loading...
