NEC DT700 - To Make Calls with Your Headset; To Answer Calls with Your Headset

BASIC PHONE OPERATION
DT700 Basic Call Operation
4-60 DT700 User Manual
Note: You cannot attach a headset to DT710 (ITL-2E) phones.
To make calls with your headset
If you are using a headset, it is assumed that the telephone handset it in the on-hook
position when you are making calls.
1 Press the Speaker key or the NewCall Soft Key to receive dial tone.
2 Enter the telephone number.
3 Press the Dial Soft Key to initiate the call, or wait a few seconds for the call to be
automatically dialed.
Note:
You can also dial the number, then press the Headset Soft Key to initiate a call.
4 A Headset icon displays on the LCD along with the call information.
Figure 4.20 Headset icon and Headset Soft Key
5 If you want to transfer the call to your telephone handset, pick up the telephone handset
to continue the call. If you want to transfer back to the headset, press the
Headset Soft Key, then place the telephone handset back on-hook.
Note:
While you are on a call, if you press the Headset Soft Key while the telephone
handset is on-hook, your call will be dropped. Make sure you pick up the
telephone handset to continue your call before you press the
Headset Soft Key.
To answer calls with your headset
If you are using a headset, it is assumed that the telephone handset it in the on-hook
position when you are answering calls.
1 While the telephone is ringing, press the Answer key.
Figure 4.21 Answer key
2 A Headset icon displays on the LCD along with the call information.
Figure 4.22 Headset icon and Headset Soft Key