NEC DT700 - To Switch between Two Calls

BASIC PHONE OPERATION
Call Transferring and Conferencing
4-66 DT700 User Manual
Note: You cannot shuttle between calls after you have joined two calls in a
conference call.
To switch between two calls
1 While on a call, press the Conf key, or press the Conf or Conference Soft Key.
Figure 4.38 Conf key on DT710 (ITL-2E) phone
Figure 4.39
Conf Soft Key on DT710 (ITL-6DE) phone
Figure 4.40
Conference Soft Key on DT730 (ITL-12D, ITL-24D, and ITL-
32D) phones
2 Use the key pad to dial the telephone number of the party to be joined in the conference.
3 Press the Dial Soft Key to initiate the call, or wait a few seconds for the call to be
automatically dialed.
4 After you have connected to the second call, press the Shuttle Soft Key to switch
between calls without joining them in a conference.
Figure 4.41 Shuttle Soft Key
The LCD will display the information for call you are currently on.
5 To join the two calls into a conference, press the Conference Soft Key.
Note:
After you have joined two calls in a conference call, you can no longer use
conference shuttle since the calls are now in one single conference call.