NEC DT700 - To Place a Second Call (Concurrent Call)

BASIC PHONE OPERATION
Call Waiting/Concurrent Calls
4-62 DT700 User Manual
Figure 4.24 Answer key
The current call is put on hold, and the new call is answered.
3 When you have completed the call, press the EndCall Soft Key to end the call and return
to your original call.
4 Press the Hold key or the Resume Soft Key to resume the original call.
Figure 4.25 Hold key
To place a second call (Concurrent call)
If it is enabled by your system administrator, you can place a new call while you are
on another call. They will be treated like two separate phone calls and you cannot
switch between phone calls. See “Conference Shuttle” on page 4-65 for instructions
on how to place a second call where you can still switch between the two calls.
For information on conference two calls, see “Conferencing Calls” on page 4-63.
1 Press the Hold key to place the current call on hold, then press the NewCall Soft Key to
get dial tone.
Figure 4.26 Hold key
Figure 4.27
Call on Hold and Resume Soft Key
2 Enter the phone number you want to call.
Figure 4.28 Enter number for second call
or
DT710 (ITL-6DE) and DST730 (ITL-12D, ITL-24D, and ITL-32D) phones
DT710 (ITL-2E) phones