NEC DT700 - To Place an Internal Call

BASIC PHONE OPERATION
DT700 Basic Call Operation
4-56 DT700 User Manual
Figure 4.7 NewCall Soft Key
2 Enter the outside line access code using the keypad (8, for example) if required, then
enter the telephone number of the outside party.
You can use the Delete Soft Key to go delete the last digit (backspace).
Figure 4.8 Enter number (external call)
3 Press the Dial Soft Key to initiate the call, or wait a few seconds for the call to be
automatically dialed.
Figure 4.9 Dial Soft Key
The call proceeds to the dialed party.
Note: You can also dial the number, then lift the telephone handset or press the
Headset Soft Key to initiate a call.
INTERNAL CALLS
To place an internal call
1 Lift the handset, press the Speaker key, or press the NewCall Soft Key to receive dial
tone.