NEC DT700 - To restart your phone

BASIC SETTINGS/CONFIGURATION
Basic Setup with the Menus and Cursor Pad
3-48 DT700 User Manual
• 1 Disable: When dialing Personal Directory or Call History entries, you will be
prompted to edit/confirm the number before the phone dials.
•
2 Enable: When dialing from the Personal Directory or Call History, numbers
will be dialed as they appear in the Personal Directory or Call History. If your
system requires an outside line access code, you may not be able to dial entries
using the Call History.
5 Press Enter b on the cursor pad or the OK Soft Key to accept the setting.
You can also press the Cancel Soft Key to exit without making any changes.
Note: For more information on the Personal Directory and Speed Dials, see
Chapter 5, “Advanced Phone Features.”
To restart your phone
1 Press the Menu key.
2 Select 5 Reboot Phone.
Figure 3.38 Main menu screen
3 Press the OK Soft Key or b Enter key on the cursor pad to restart the phone.
Figure 3.39 Confirm Reboot
You will not have a dial tone on the phone or be able to make calls until the phone
restarts and re-registers on the network.
Note: If you cannot restart the phone using the Menus if your phone is locked up,
unplug the phone from power and the network for ten seconds, then reconnect
the telephone to your network and power to perform a
restart.
VIEWING PHONE SETTINGS
If you are having problems with your phone, you may want to view the hardware
version, firmware version, or network information for your phone.
Note: You cannot change these settings on your phone. To change any of these
settings, contact your system administrator.