. . . . .
BASIC PHONE OPERATION
DT700 Basic Call Operation
DT700 User Manual 4-55
Lift the telephone handset.
• Using the speaker:
Press the Speaker key.
• Using a headset:
Press the Answer key.
• If you are in the Personal Directory, Call History or Menu screens:
Press the Line Key to view the caller information, then use one of the methods listed
above to answer the call.
Note: If you are changing any settings on your phone or adding a Personal Directory
or Speed Dial entry, your changes will be discarded and not saved if you press
the Line Key to view the incoming call.
To reject an incoming call
• Press the Reject Soft Key.
Figure 4.6 Reject Soft Key
The call will be routed to your voice mail box (if enabled on your system) or routed in
accordance with your defined forwarding conditions.
INCOMING CALL RINGING TONES
Different ring tones can be used to distinguish between internal, external ringing, and
auto answer (intercom-call) ring back ringing. The cadences of the ring tones are
established through configuration parameters. For more information about the
incoming call ringing tones for your system, contact your system administrator.
Note: Soft Ring is only valid for iS3000-SIP@Net platforms. Contact your system
administrator to determine if Soft Ring is available on your system.
PLACING CALLS
EXTERNAL CALLS
To place an external call
Calls made to numbers that are outside of your system usually require an outside line
access code.
1 Lift the handset, press the Speaker key, or press the NewCall Soft Key to receive dial
tone.
To Next Page
Loading...
