BASIC PHONE OPERATION
Call Transferring and Conferencing
4-68 DT700 User Manual
Figure 4.45 Blind Soft Key
3 Press the Dial Soft Key, or wait a few seconds for the call to be automatically dialed.
4 The call is immediately transferred when the number is dialed. You will be disconnected
from both callers.
If your system administrator has enabled forwarding to external numbers, you may be
able to transfer calls to external numbers. You will be disconnected from both calls
when your phone dials the external number.
Unattended transfer
An Unattended Transfer can be done if you want to do a blind transfer where you do
not wait to see if the other caller answers the call, but you did not use the Blind Soft
Key.
If the other caller does not answer or rejects the call, the call is routed to voice mail or
according to forwarding conditions. If there is no voice mail or forwarding conditions
set for the line you transfer to, the call will continue to ring.
1 While on a call, press the Transfer key.
Figure 4.46 Transfer Key
This puts the current call on hold so you can start to transfer the call.
2 Use the key pad to dial the telephone number to which the call is to be transferred.
Figure 4.47 Transfer Call
3 Press the Transfer key or hang up the telephone handset. You will be disconnected from
both calls.
TRANSFER SHUTTLE
If you are doing an attended transfer and you are connected to both parties, you can
shuttle between the two calls before you transfer the calling party to the other party.
To Next Page
Loading...
