Important Information
5
Power Supply
• The projector is so designed that it
operates with the power supply voltage
described below.
• Projector:
AC 100-240 V 50/60 Hz
Single-phase
• Lamp Power Supply:
-NC-32PS01:AC 200-230 V 50/60 Hz
Three-phase
-NC-32PS02:AC 380-415 V 50/60 Hz
Three-phase
Ensure that your power supply fits this
requirement before attempting to use
your projector.
• Consult your dealer about installing the
power cable to the projector. DO NOT
install the power cable by yourself. Doing
so may cause a fire or electric shock.
• Handle the power cable carefully and
avoid excessive bending. Do not place any
heavy objects on the power cable. A
damaged cable can cause electric shock or
fire.
• If the projector will not be used for an
extended period of time, shut down AC
power.
• Placing the power cable and the signal
cable closely to each other can cause beat
noise. Beat noise is corruption of the
picture often seen as a rolling band
moving through the image. Keep the two
separated, to ensure beat noise is not
generated.
• Do not touch the projector during a
thunder storm. Doing so can cause
electrical shock or fire.
Cleaning
• When performing maintenance work on
the projector, turn off the projector main
unit and lamp power supplies, disconnect
the power plug of the projector main unit,
and shut down the circuit breaker to which
the AC power cord of the lamp power
supply is connected to ensure safety.
• Clean the cabinet periodically with a damp
cloth. If heavily soiled, use a mild
detergent. Never use strong detergents or
solvents such as alcohol or thinner.
• Use a blower or lens paper to clean the
lens, and be careful not to scratch or mar
the lens.
Fire and Shock Precautions
• Ensure that there is sufficient ventilation
and that vents are unobstructed to
prevent potentially dangerous
concentrations of ozone and the build-up
of heat inside your projector. Allow at least
8 inches (20 cm) of space between your
projector and a wall. Allow at least 20
inches (50 cm) of space between the
ventilation outlet of the lamp power
supply and an object. Connect the
projector exhaust outlet with the exhaust
equipment having a capacity of 16 m
3
/min
or more.
• Prevent foreign objects such as paper
clips and bits of paper from falling into
your projector. Do not attempt to retrieve
any objects that might fall into your
projector. Do not insert any metal objects
such as a wire or screwdriver into your
projector. If something should fall into
your projector, disconnect it immediately
and have the object removed by a
qualified service person.
• Do not place any liquids on top of your
projector. Refer servicing to qualified
service personnel if liquid has been
spilled.
• Keep any items such as magnifying glass
out of the light path of the projector. The
light being projected from the lens is
extensive, therefore any kind of abnormal
objects that can redirect light coming out
of the lens, can cause unpredictable
outcome such as fire or injury to the eyes.
• Do not cover the lens with the supplied
lens cap or equivalent while the projector
is on. Doing so can lead to distorting or
melting of the cap and burning your hands
due to the heat emitted from the light
output.
• When using a LAN cable: For safety, do
not connect to the connector for
peripheral device wiring that might have
excessive Voltage.
CAUTION:
• High Pressure Lamp May Explode if
Improperly Handled. Refer Servicing to
Qualified Service Personnel.
• Always ask your distributor to performing
cleaning and maintenance inside the
projector.
To Next Page
Loading...
Need help?
General
